1. To set the delay times (set times) press the key, the
SET
LED will illuminate and the display will show (parameter acronym) and its
programmed value. To change the value press the key to increase the value shown or the key to decrease it. Note: Press the keys for
longer than 1 second to increase/decrease the numerical value more quickly.
Through programming the parameter it is possible to select which set times can be set in this fast mode. An option also exists which allows the
setting of the set time value only using the keys without pressing the key in advance ( = 8). The options for the parameter
are as follows:
oF
No set time can be set with the short key (if pressed and released the key has no effect).
1
Only set time value can be set with this procedure.
2
Only set time value can be set with this procedure.
3
and set time values can be set with this procedure.
4
Only set time value can be set with this procedure.
5
and set time values can be set with this procedure.
6
and set time values can be set with this procedure.
7
, and set time values can be set with this procedure.
8
set time value can be set directly with the keys.
For example, when the parameter is set to
1
or
3
, the procedure is as follows:
- Press and release the key, the display shows alternated with the value.
- To change the set time, press the key to increase the value or the key to decrease the value.
- If =
1
, once the desired value has been set, press the key to exit the set time programming mode.
- If =
3
, pressing and releasing the key the display shows alternating with the value. To change the value use the keys using the
same method as for the value.
- Once the set time(s) have been programmed, press the key to exit the set time programming mode. If no key is pressed for over 10 seconds the
display will automatically return to normal operation.
x and can be set within the limits established by parameters and and can be set within the limits estblished by and
. .
Page 4
SET TIME PROGRAMMING (FAST MODE)
PARAMETER SETTING MODE
To access the timer function parameters when passcode protection is disabled, press the key for 5 seconds, after which the display shows the code
that identifies the first programmable parameter. Use the keys to select the desired parameter then press the key, the display will then show
the parameter code, alternated with its value, that can then be changed with the keys. Once the desired value has been reached, press the
key again to store the new value, the display will then return to show the parameter code. Press the keys to select any other desired parameters
and change them using the same method. To exit the programming mode, press no key for 30 seconds or keep the key pressed for 2 seconds. The
timer display will then return to showing the timing count value.
PARAMETER PROTECTION USING A PASSCODE
The timer has a parameter protection function using a passcode that can be personalised through the parameter. To protect the parameters, set the
x parameter to your desired passcode number.
When the passcode protection is active, press the key for 5 seconds after which the display shows . Press the key and the display will show .
Using the keys, enter the programmed passcode number and press the key again. If the passcode is correct the timer will display the code of
the first programmable parameter and it is possible to program the timer as previously described.
The passcode protection can be disabled by setting =
oF
.
Notes:
1. All parameters are configured by default as protected so that by simply setting the parameter they are all protected by the passcode.
2. If the passcode is lost, switch the timer OFF then ON, pushing the key during initial test and keeping it pressed for 5 seconds. All programmable
parameters are then accessible and parameter can be set as required.
INSERT CORRECT
PASSWORD
PARAMETERS
(PROGRAM MODE)
PASSWORD
REQUEST
