OUT2
Please read this document carefully before using this product. The product guarantee will become invalidated by any damage to the timer
caused by not following the instructions in the user manual. Tempatron do not accept any liability for personal injury, material damage or capital
losses which may arise by not following the instructions in the user manual.
• 4 digit red LED display panel mounting digital timer
• 5 programmable timing modes
• Time ranges from 0-99.99sec to 0-9999hrs
• 24Vac/dc or 100-240Vac powered
• 1 changeover and 1 N/O relay output
• Programmable reset function
• Easy to programme through front keys
• Status and timing indicators
• Selectable up/down timing
• EEPROM memory (minimum 10 years)
• Security passcode
• IP65 enclosure
ENVIRONMENTAL CONDITIONS
Operating/Storage Temperature:
0ºC to +50ºC / -20ºC to +60ºC
Protection Class:
IP65
Maximum Installation Height:
2000m
Do not use this timer in locations where corrosive or flammable gases could be present.
ELECTRICAL
Power Supply Voltage:
24Vac/dc or 100-240Vac
Power Consumption (Burden):
<
3VA
Frequency
50/60Hz
Wiring:
2mm² screw type terminals
Data Retention:
EEPROM (minimum 10 years)
CE Markings:
Directive LV 2014/35/EU
(EN 60730-1, EN 60730-2-7, EN 61812-1, UL 508)
Directive EMC 2014/30/EU
(EN 55011: class B; EN 61000-4-2,
EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, EN 61000-4-6)
OUTPUTS
Relay Outputs (R1 & R2):
Out1: Single pole changeover contact 16A rated at 240Vac (resistive load)
Single pole changeover contact 16A rated at 240Vac (resistive load)
Out2: Single pole N/O contact 5A rated at 240Vac (resistive load)
Single pole N/O contact 5A rated at 240Vac (resistive load)
Relay Contact Life:
Mechanical 1,000,000 operations
Electrical 100,000 operations
Reset Time:
100ms approx.
Accuracy:
±3sec/24hours
HOUSING
Housing Type:
Panel mounting
Display:
4 digit red LED display
Dimensions:
78mm wide x 35mm high x 64mm deep
Weight:
Approximately 130g (without packaging)
Enclosure Materials:
Self extinguishing plastics, UL 94 V0
TECHNICAL SPECIFICATION
Page 2
WIRING CONNECTIONS
When cleaning the timer, solvents (thinners, gasoline, acid etc.) or corrosive materials must not be used.
OUT1
2
1
4
3
5
6
7 8 9 10 11 12
(-)
~
SUPPLY
(+)
~
INPUTS
RST CNT
