Please read this document carefully before using this product. The product guarantee will become invalidated by any damage to the timer
caused by not following the instructions in the user manual. Tempatron do not accept any liability for personal injury, material damage or capital
losses which may arise by not following the instructions in the user manual.
• 4 digit backlit LCD display digital timer
• 24 programmable timing modes
• 0-9999sec or 0-9999min time ranges
• 24 to 240Vac/dc powered
• 1 changeover and 1 N/O relay output
• Easy to programme through front keys
• Status and timing indicators
• EEPROM memory (minimum 10 years)
• IP20 enclosure code
• DIN rail mounting
• 2 module 36mm width
• Clear hinged tamperproof cover
ENVIRONMENTAL CONDITIONS
Operating/Storage Temperature:
-5ºC to +45ºC / -10ºC to +55ºC
Protection Class:
IP20
Installation Height:
Maximum 2000m
Do not use this timer in locations where corrosive or flammable gases could be present.
ELECTRICAL
Power Supply Voltage:
24 to 240Vac/dc
Power Consumption (Burden):
<3VA
Frequency
50/60Hz
Wiring:
2mm² screw type terminals
Data Retention:
EEPROM (minimum 10 years)
CE Markings:
EN 60947-5-1:2004+A1:2009, EN 60730-1:2012,
EN 60730-2-7:2011+AC:2012, EN 61000-6-2:2005,
EN 61000-6-4:2007+A1:2011, EN 61000-3-2:2014, EN 61000-3-3:2013
OUTPUTS
Relay Outputs (R1 & R2):
R1: Single pole changeover contact 8A rated at 240Vac (resistive load)
Single pole changeover contact 8A rated at 240Vac (resistive load)
R2: Single pole N/O contact 8A rated at 240Vac (resistive load)
Single pole N/O contact 8A rated at 240Vac (resistive load)
Relay Contact Life:
Mechanical 1,000,000 operations
Electrical 100,000 operations
Reset Time:
100ms approx.
Accuracy:
±3sec/24hours
HOUSING
Housing Type:
DIN rail mounting 2 module width
Display:
Backlit LCD display
Dimensions:
36mm wide x 90mm high x 65mm deep
Weight:
Approximately 140g (without packaging)
Enclosure Materials:
Self extinguishing plastics
TECHNICAL SPECIFICATION
Page 2
WIRING CONNECTIONS
S
16
25 28 A1 A2
(-)
~
24-240Vac/dc
Supply
(+)
~
15
18
R1
R2
~ (+)
(START)
When cleaning the timer, solvents (thinners, gasoline, acid etc.) or corrosive materials must not be used.
