3
Temco ADF3310 Series
78623
Important Information
INSTALLER: Please leave these instructions with the
owner.
OWNER: Please retain these instructions for future
reference.
IMPORTANT: READ THESE INSTRUCTIONS CARE-
FULLY BEFORE OPERATING.
•
If this is the ONLY gas appliance, we recommend a
minimum 200 pound cylinder with a fill gauge. Use of a 100
pound cylinder is not recommended. Other household gas
appliances may require the tank size to be larger. Do not
operate the vent-free heater if the fuel level in the propane
tank is below 1/4 full.
•
Use only with two-stage regulator.
•
DO NOT use this heater if any part of it has been under
water. Immediately call a qualified technician to inspect the
appliance and replace any part of the control system and any
gas control which has been under water.
•
Check local, state or city codes to determine if unvented
heaters are permitted.
•
This appliance may be installed in an after-market* manufac-
tured "mobile" home where not prohibited by state or local
codes.
*After-market: Completion of sale, not for purpose of re-sale from the
manufacturer.
•
The appliance must not be used with glass doors.
•
To assure proper operation of the oxygen depletion pilot,
outside ventilaiton air cannot be introduced into the fireplace.
•
Young children should be carefully supervised when they are
in the same room with the appliance
•
An unvented room heater having an input rating of more than
10,000 btu per hour shall not be installed in a bedroom or
bathroom.
IMPORTANT: Read these instructions carefully before
beginning installation.
•
Due to high temperatures, the appliance should be
located out of traffic and away from furniture and draper-
ies.
•
Installation and repair must be done by a qualified service
person or gas appliance installer.
•
A fireplace screen must be in place when the appliance is
operating. On models with movable screens, the screens must
be closed when the fireplace is operating.
•
The appliance must be inspected before use and at least
annually by a professional service person. More frequent
cleaning may be required due to excessive lint from carpeting,
bedding material, dust and pet hair, etc. It is important that the
control compartment, burners and circulating air passageways
of the appliance be kept clean.
•
DO NOT place clothing or other flammable material on or
near the appliance.
•
This appliance must only be used with pressures at the inlet
as shown in Table 1, Page 11 in installation instructions.
•
The installation must conform with local codes or, in the
absence of local codes, with the NATIONAL FUEL GAS CODE,
ANSI Z223, latest edition.
•
Any safety screen or guard removed for servicing an appli-
ance must be replaced prior to operating the heater.
•
The appliance and its appliance main gas shut-off valve must
be disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of
1/2 psig (3.5 kpa).
•
The appliance must be isolated from the gas supply piping
system by closing its equipment shut-off valve during any
testing of the gas supply piping system at test pressures equal
to or less than 1/2 psig (3.5 kpa).
•
Models ADF3310N-4 and ADF3310P-4 may be installed in
sleeping quarters where permitted by local codes. DO NOT
install any model in recreational vehicles or in a bathroom.
WARNING: During manufacturing, fabricating and
shipping, various components of this appliance are
treated with certain oils, films or bonding agents. These
chemicals are not harmful but may produce annoying
smoke and smells as they are burned off during the
initial operation of the appliance, possibly causing
headaches and eye/lung irritation. This is a normal and
temporary occurrence.
WARNING: Do not use a blower insert, heat exchanger
insert or other accessory not approved for use with this
heater.
WARNING: If the area in which the heater may be oper-
ated is smaller than that defined as an unconfined space
or if the building is of unusually tight construction,
provide adequate combustion and ventilation air by one
of the methods described in the National Fuel Gas code,
ANSI Z223.1, section 5.3 or applicable local codes.
This heater shall not be installed in a confined space or
unusually tight construction unless provisions are
provided for adequate combustion and ventilation air.
WARNING: Any change to this heater or its controls can
be dangerous.
This appliance is only for use with the type of gas indi-
cated on the rating plate. This appliance is not convertible
for use with other gases.
WARNING: Do not allow fans to blow directly into the
fireplace. Avoid any drafts that alter burner flame pat-
terns.
WARNING: Failure to keep primary air opening(s) of the
burner(s) clean may result in sooting and property
damage.