SX4e CDMA 800 • SX4e CDMA 1900
5
Technical Manual
Connect Your Phonecell SX4e to AC Power
1) Connect the barrel connector of the power supply to the AC power input receptacle of the
Phonecell SX4e -
See Figure 5
.
2) Plug the power supply into the AC socket.
3) Press and hold the power button until the power LED is green -
See Figure 5 and Figure 8.
4) Check the cellular signal strength and move the unit (or external antenna) until you achieve the
best signal possible - see the
Received Signal Strength
section of this guide.
Emergency Battery Backup
How to Install the Battery
1) Open the battery cover on the bottom side
of the SX4e -
See Figure 6
.
2) Connect the battery cable to the battery
connector inside the battery compartment.
3) Insert the battery pack into the battery
compartment between the hold bars.
4) Close the battery cover.
Plug in Your Telephone
1) Locate the modular line port on your
telephone and plug in one end of a
standard phone cord -
See Figure 7.
2) Connect the other end of the phone cord
to the telephone port on the side of the
SX4e -
See Figure 7.
NOTE:
The SX4e does not support direct
computer modem (data) operation through the
phone port or fax port. See the
Digital Data
Service
section of this guide for computer
digital data operation.
Battery
Cover
Tabs
Figure 6 – SX4e battery installation.
Battery
Cover
Battery
Cable
Battery
Figure 7 – Connect SX4e to telephone.
Phone Cord
To
Phone
Port
Figure 5 – SX4e AC power input.
AC Power Input
Power Button
AC Power
Power
Supply
Barrel Connector
