SX4D GSM 900 • SX4D GSM 1800
31
U
SER
M
ANUAL
Phonecell SX4D Programming - continued
Exit Programming Mode
The programming mode can be exited by any one of the following:
1. Go “off-hook” (pick up handset)
2. Failure to enter the correct password three times (technician mode only)
3. Failure to enter any digit within two minutes.
The
PM
(
Programming Mode)
icon is then turned off, returning the Phonecell
SX4D to the
Normal Mode
.
Phonecell SX4D User-Programming Commands
The following commands are displayed when in the user programming mode. An
<
entered value
> is comprised of the digits 0 through 9.
How to Enter Call Alert Volume
The following key sequence is used to enter the volume of the call alert:
Label: CALL ALERT VOL
Data: <volume>
The volume value is set to
0
for off;
1
for low; and
2
for high. If the
volume value is greater than 2, it is considered invalid. The factory
default is
2
.
Enter Auto Send Delay
The following key sequence is used to enter the auto send delay:
Label: AUTO SEND DELAY
Data: <delay>
If the delay is not in the range of
2
to
20
seconds, it is considered
invalid. The factory default is
3
.
Enter RSSI Display Type Option
The following key sequence is used to select the RSSI display option:
Label: RSSI DISPLAY
Data: <type>
The type value is set to
0
for direct readout in dBm or
1
for bar graph.
If the RSSI display type value is greater than 1, it is considered invalid.
The factory default is
0
.
Enter LCD Display Contrast
The following key sequence is used to enter the LCD Display Contrast:
Label: LCD CONTRAST
Data: <contrast>
If the LCD contrast is not in the range of
0
(darkest contrast) to
19
(lightest contrast), it is considered invalid. The factory default is
10
.
Enter Zero-Delay Dial
The following key sequence is used to enter the Zero Delay Dial option:
Label: ZERO-DELAY DIAL
Data: <zero-delay dial>
The zero delay dial value is set to
0
for Disable and
1
for Enable. The
factory default is
1
(Enable).
