Teltonika TST100, Быстрое руководство

Страница: 5 / 14

5
TST100 | Wiki
Set up your device
1. Insert Micro-SIM card as shown with PIN request disabled or
read our Wiki how to enter PIN later in Teltonika
Configurator . Make sure that Micro-SIM card cut-off corner is
pointing forward to slot.
2. Connect battery as shown to device.
3. Connect micro usb cable as shown
4. To power up TST100, connect green plug to the E-scooter
5. Open Teltonika configurator, select TST100 device and
configure it according to your requirements (how to install
drives on page 6)
.
6. Once all done, disconnect TST100 from PC and E-scooter. Attach
the lid by two screws as shown
NOTE: E-scoter Firmware should be V3.1.1 or higher. Please
contact Segway-Ninebot for firmware updates.
How to insert Micro-SIM card and
connect the battery