Teltonika FMB630, Руководство пользователя

Страница: 123 / 173

123
CAN ID – this is 4 byte identifier. Messages use 4 bytes, but the first and last bytes may
differ in different vehicle models while the middle four bytes are the same for all vehicles. The
first and last bytes may have any value. Because of this reason it is recommended to write FF in
the first byte and the same in the last byte.
This information is provided only as an example and Teltonika
takes no responsibility for information accuracy or damage that may be done
to the vehicle or FMB630 module while integrating it.
Example:
All Mercedes Benz Actros 2 models with Vehicle Identification Number (VIN) starting with
WDB93 have a possibility to connect FMB630 module to CAN bus. This can be done by
connecting to special PSM module (which may or may not be included in the truck) or ground
module of the vehicle. For CAN signal to be available, parameter 520 must be enabled in
“kommunikationsschnittstelle” in the vehicle with Mercedes Stardiagnose.
CAN wires can be found on X5 connector located in the fuse box (Figure 91):
Pin 5: CAN Low signal (yellow wire)
Pin 2: CAN High signal (blue wire)
Figure 91 X5 plug on Mercedes Benz
In the example FMB630 will filter all CAN messages with identifier FFFEE9FF (fuel
consumption) (Figure 92).
Figure 92 CAN parameter configuration example
Note: Averaging constant cannot be used with CAN data, because this
information comes in digital format. So in order to prevent data loss, set
Averaging constant parameter to 1.