START-S3XL
Technical Manual
Using the unit improperly and performing repairs or modifi cations personally will void the warranty. The producer
declines any responsibility for damages due to inappropriate use of the product and due to any use other than the
use the product was designed for. The producer declines any responsibility for consequential damages except civil
liability for the products.
Every programming and/or every maintenance service should be done by qualifi ed technicians.
1.1
Safety precautions
1
Introduction
The START-S3XL electronic control unit is used to control the movement of entrances, swinging gateways, rolling
gates and automatic doors. It can be connected to a hydraulic or electromechanical actuator equipped with an
asynchronous, single-phase motor operating at a voltage of 230 Vac.
1.2
Field of application
1.3
Type of installation
These two simple diagrams show only one of the possible applications for this control unit. The risks inherent to
the “MACHINE” and the user’s requirements must be analyzed in depth in order to establish how many elements
need to be installed. All photocells have a system of synchronism that makes it possible to eliminate interference
between two pairs of photocells (for other details, see the instructions for the photocells). In the diagram, the pair of
photocells “Photo A” (considered in this control unit) has no effect during opening while it causes a total inversion
during closing.
“Photo A2”
is connected in series to
“Photo A”
.
Application on sliding automation
Application on swinging automation
FOTO A
FOTO A
FOTO A2
We recommend to install a STOP switch which stops immediatelly the gate. The switch has a normally close contact
which opens the contact when it is working. See Par. 2.7
Dimensions
87 x 126 x 40
mm
Weight
0.46
Kg
MAX power of single motor
1
750
4
HP
W
A
MAX power of signal light 230 Vac
40
W
MAX absorption with clean contact
2
A
MAX absorption 24 Vac/dc
300
mA
MAX absorption 12 Vdc
50
mA
1.4
Technical features
-3-
