Telsa TS 8643, Инструкция пользователя

Страница: 7 / 40

EN -6-
• When removing ice from the ice-making compartment, do not touch it. Ice
may cause frost burns and/or cuts.
• Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes
immediately after you have taken them out of the ice-making compartment.
• Do not re-freeze frozen goods after they have melted. This may cause health issues
such as food poisoning.
• Do not cover the body or top of fridge with lace. This affects the performance of your
fridge.
• Secure any accessories in the fridge during transportation to prevent damage to the
accessories.
Installing and operating your fridge freezer
Before starting to use your fridge freezer, you should pay attention to the following points:
• The operating voltage for your fridge freezer is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge freezer where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and at least 5 cm away from electrical ovens.
• Your fridge freezer should never be used outdoors or exposed to rain.
• When your fridge freezer is placed next to a deep freezer, there should be at least 2 cm
between them to prevent humidity forming on the outer surface.
• Do not place anything on your fridge freezer, and install your fridge freezer in a suitable
place so that at least 15 cm of free space is available above it.
• Do not place heavy items on the appliance.
• Use the adjustable levelling feet to make sure your appliance is level and
stable. You can adjust the levelling feets by turning them in either direction.
This should be done before placing food in the fridge freezer.
• Before using your fridge freezer, wipe all parts with a solution of warm
water and a teaspoon of sodium bicarbonate, then rinse with clean water and dry.
Place all parts in the fridge after cleaning.
If your refrigerator has a fan condenser:
The condenser of your fridge is placed at the bottom of cabinet. As a result of that, assemble
the spacer by fixing it to holes on the cover bottom panel and turn 90° that’s shown below
figure for arranging the distance between the refrigerator and the back wall at where you
place the fridge. You can move the fridge towards the back wall until that point.
Plastic for distance setting