Avanti 3015ip Installation Notes
6
5.4 T
HE
S
ETUP
P
ROCEDURE
1. To begin the Setup procedure, connect the Avanti 3015ip to the
power source while at the same time holding down the
[SPEED DIAL/PROGRAM]
button. After a few seconds the dis-
play shows:
Phone Configuration
<Boot> <Edit> <Info>
{Info}
displays general phone information like the MAC address.
{Boot}
initiates the startup process.
2. Press
{Edit}
to enter the Setup procedure,
The display shows
IP Menu
?
The softkeys change to
{YES}
and
{NO}
. From this point on,
unless indicated otherwise, the left softkey will display the next
choice in the menu, and the middle softkey the previous one.
3. Press
{YES}
The display shows
DHCP - Y
The value of the DHCP (Dynamic Host Configuration Protocol)
parameter should be Yes, unless you know there is no DHCP
Server.
After pressing the
{NEXT}
softkey, you are asked whether you
want to proceed
4.
Exit this menu?
5. Press
{NEXT}
to proceed, or
{BACK}
to return to the DHCP
parameter.
If DHCP = Yes
(otherwise proceed to step 11.) you are asked:
Use DHCP FTP - Yes
6. The FTP server is were the application software resides. If no FTP
Server IP address was programmed on the DHCP Server (ask the
organization’s IT manager for details on the DHCP Server config-
uration), you should change this parameter’s value to No. Other-
wise, press
{NEXT}
to continue to step 9.
7. If you changed the value of the DHCP FTP option to No, you will
be asked to enter the IP address of the TVSe FTP Server:
FTP Server IP Addr.
8. Enter the address of the TVSe FTP Server and press
{NEXT}
.
9. The TVS Menu prompt appears:
TVS Menu
10. Press
{YES}
to enter the TVS Menu, or
{NO}
to proceed to the
User Menu.
11. If the DHCP value was No, you will be asked for the extension’s
IP address:
Phone IP Address
[192.333.22.123]
or other address previously modified.
12. Enter the extension’s IP address
TIP
You can navigate along
the DN line by pressing
[LO HI]
when the TVS User
DN screen is displayed.
If the currently stored DN
has four digits and you wish
to enter a shorter number,
move the cursor leftward by
pressing the
LO
side of the
[LO HI]
button until it
reaches the beginning of the
line and the unwanted digits
disappear.