4.
Attach the Cross Section to the Mid Frame Section as
shown using four 1/4” X 1/2” hex bolts and four 1/4” lock nuts.
Important:
The Cross Section must be oriented as shown so
that the tapered Cross Arm storage pockets (“A” in the photo
above) are over the lower Cradle Support (“B” in the photo
above). The narrow ends of the pockets must be down.
A
B
Narrow ends of
tapered pockets
must be down
as shown.
5.
Attach the Upper Cradle Holder Assembly to the Upper
Frame Section as shown using four 1/4” X 1/2” hex bolts and
four 1/4” lock nuts.
Important:
The Upper Cradle Holder Assembly must be
oriented as shown so that the retaining catch (“A” in the photo
above) is up and the support angles down.
Tighten the fasteners only finger tight at this point.
A
Adjusting Upper Cradle Holder Assem.
After hand tightening the fasteners on the Upper Cradle
Holding Assembly you will need to adjust the Support to prop-
erly fit the Cradle of the PANELLIFT
®
Model 138-2 that will be
stored there.
A
B
3
6.
Begin by taking up the Cradle and holding it oriented as
shown in the photo above with the tapered Cross Arm pock-
ets (“A”) away from you and the Pivot Box (“B”) projecting to
your right.
A
