Telme GEL 20, Руководство по эксплуатации

Страница: 16 / 24

English
Ice cream freezer
16
1) Separately wash all those parts which can be dismantled by the user following instructions in Par. 7.2. Only
use warm water and food compatible detergent, followed by a cool rinse.
Note: For a long life of the machine we suggest not to use too hot water, solvents, abrasive detergents, or
rough sponges, in particular on the plastic parts.
2) Thoroughly wash all those parts of the machine which are fixed:
- cylinder drain (or extraction door) using the supplied tube-brush;
- top and inside of the cylinder;
- front panel and its components, taking care as to avoid letting water into electric controls.
7.4 Reassembly
T
HESE OPERATIONS MUST BE CARRIED OUT ONLY AFTER DISCONNECTING MACHINE FROM
MAIN POWER
!
- Assemble blades [31] on beater's supports [6] partially screwing screws [36].
Blades will be subsequently adjusted.
Carefully place beater into the cylinder, taking care to keep it
vertical without dropping it.
- The slot on the beater's hub [27] goes into the shaft clutch [28];
- FIRMLY tighten beater's fixing knob [7];
Before tightening knob [7], always check that the gasket [G] is
in perfect conditions and in place, an that is clear of any fat as
to prevent knob from accidentally coming loose. Should the
knob fall into the cylinder during production cycle, it would
cause serious damage to the machine.
Note: Gaskets must be periodically replaced (ref. Par. 8.1).
- put lid in place. If supplied with hinges, insert pin [25];