Install the E
E IO&M Guide
Telkonet, Inc.
For Use with Firmware Version 2.x
20800 Swenson Drive, Suite 175
Install the E
Waukesha, WI 53186
Revision 5
(414) 302-2299
Page 12
www.telkonet.com
14.
Note the J2 pin as shown in Figure 1; this is the pin to which you will connect power.
15.
Note the J2 wires coming out from the wall or battery pack.
16.
You will attach the J2 wires to the J2 pin.
Do NOT apply wire nuts while the circuit is energized. Wire-nut the connection in a
de-energized state.
o
If your power is an AC 24V transformer, then connect the red wire and black wire to the top 2
pins; it does not matter whether the red wire is on top and the black wire is in the 2nd slot
from the top, or vice versa.
o
If your power is a 12-24VDC installation, then connect the black wire to the top pin (this is the
“Ground” or “Common” pin) and connect red wire to the 2
nd
pin-the pin just below the top pin
(this is the “Power” pin).
17.
Place the cover over the backplate, about ¼” to the left as shown in Figure 8.
Figure 8: Replace Cover
18.
Slide the cover to the right to secure it.
19.
Screw in the security screw.
Your E is now installed.
Next, associate your devices (join to network, bind, pair).
