Telmoss
user’s guide
7/42
2004. Telital mobitel d.o.o. All right reserved.
7. power supply presence indicator (lights if power supply is ok, but only after
boot sequence which takes ca.55 seconds after switching on)
8. GSM signal strength indicator (3 levels)
9. traffic/communication indicator (blinks if there is rx/tx traffic)
10. video signal indicator (light red if video signals are presented)
Telmoss
user’s guide
8/42
2004. Telital mobitel d.o.o. All right reserved.
INSTALLATION
CAUTION
Telmoss device should not be used in an explosive environment (petrol
stations, refineries, fuel depots, chemical plants etc.) unless it is housed in
an approved explosion protection enclosure.
Telmoss device is to be positioned at least 20 cm from the human body
during it's operation.
Mounting the central unit
Telmoss device must be installed at the proper position where GSM signal coverage is
good enough. The unit can be mounted either on the wall or on the table. From the
security reasons, like other video surveillance systems, the main unit should be hidden
somewhere inside observed area in order not to be easily reachable nor visible.
Once the final position for central unit is defined, all cables (power adapter cable,
coaxial from cameras and wires from sensors) must reach appropriate connectors at
the unit (see Figure 3).
NOTE
Camera and sensor mounting procedures are out of the scope of this manual.