Telit Wireless Solutions LE910-SKG, Справочник команд AT

Страница: 69 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 69 of 273
+CPWD - Change Facility Password
Reference 3GPP TS 27.007
+CAOC - Advice Of Charge
AT+CAOC=
<mode>
Set command refers to the Advice of Charge supplementary services that enable
subscriber to get information about the cost of calls; the command also includes the
possibility to enable an unsolicited event reporting of the Current Call Meter
(CCM) information.
Parameter:
<mode>
0 - query CCM value
1 - disables unsolicited CCM reporting
2 - enables unsolicited CCM reporting
Note: the unsolicited result code enabled by parameter
<mode> is in the format:
+CCCM: <ccm>
where:
<ccm> - current call meter in home units, string type: three bytes of the CCM
value in hexadecimal format (e.g. “00001E” indicates decimal value 30)
Note: the unsolicited result code
+CCCM is sent when the CCM value changes, but
not more than every 10 seconds.
AT+CAOC? Read command reports the value of parameter <mode> in the format:
+CAOC: <mode>
AT+CAOC=? Test command reports the supported values for <mode> parameter.
Reference 3GPP TS 27.007
Note +CAOC command returns an estimate of the cost of the current call only, produced
by the MS and based on the information provided by either AoCI or AOCC
supplementary services; it is not stored in the SIM.
+CPOL - Preferred Operator List
AT+CPOL=
[<index>][,<format>
[,<oper>[,<GSM_AcT
>,
<GSM_Compact_Ac
T>,
<UTRAN_AcT>,<E-
UTRAN_AcT>]]
Execution command writes an entry in the SIM list of preferred operators.
Parameters:
<index> - integer type; the order number of operator in the SIM preferred operator
list
1.. n
<format>
2 - numeric
< oper > - string type
<GSM_AcT> - GSM access technology