Telit Wireless Solutions LE910-SKG, Справочник команд AT

Страница: 152 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 152 of 273
#VAUX- Auxiliary Voltage Output Control
<stat>
0 - output off
1 - output on
2 - query current value of
VAUX pin
Note: when
<stat>=2 and command is successful, it returns:
#VAUX: <value>
where:
<value> - power output status
0 - output off
1 - output on
Note: the current setting is stored through #VAUXSAV
AT#VAUX? Read command reports whether the Auxiliary Voltage pin output is currently
enabled or not, in the format:
#VAUX: <value>
AT#VAUX=?
Test command reports the supported range of values for parameters <n> , <stat> .
#VAUXSAV - Auxiliary Voltage Output Save
AT#VAUXSAV
Execution command saves the actual state of #VAUX pin to NVM. The state will
be reload at power-up.
AT#VAUXSAV=?
Test command returns the OK result code.
#V24CFG - V24 Output Pins Configuration
AT#V24CFG=<pin>,
<mode>
Set command sets the AT commands serial port ( UART ) interface output pins
mode.
Parameters:
<pin> - AT commands serial port interface hardware pin:
0 - DCD (Data Carrier Detect)
1 - CTS (Clear To Send)
2 - RI (Ring Indicator)
3 - DSR (Data Set Ready)
4 - DTR (Data Terminal Ready). This is not an ouptput pin: we maintain this
value only for backward compatibility, but trying to set its state raise the result
code “
ERROR
” (not yet implemented)
5 – RTS (Ready To Send). This is not an ouptput pin: we maintain this value only
for backward compatibility, but trying to set its state raise the result code
“
ERROR
”
<mode> - AT commands serial port interface hardware pins mode:
0 - AT commands serial port mode: output pins are controlled by serial port device