1VV0301421, Rev 1.2
Copyright © 2017 Telit. All rights reserved.
Step
2
Serial terminal displays the board information with
Firmware Version details and the command list:
Note:
After every command, enter any key to EXIT from
DEEPSLEEP mode.
Step
6
From any iOS device, open Wi-Fi settings and connect to
the same wireless network to which SKB was connected.
Step
3
To run the Light Sensor Demo, type “demo 2”.
Step
4
Connect to a Network.
Note:
Connecting to a Network can be performed in two
ways:
1. Manual Method - Using SSID and PWD Commands.
2. WAC Provisioning - Refer
GS2K Hostless HomeKit User
Guide, section - WAC Provisioning under Chapter-4
.
This QSG provides steps for manual method.
Step
5
Enter the below commands:
- Enter “SSID” command.
-
Example: SSID
GainSpanDemo
- Enter “PWD” command.
-
Example: PWD 1234567890.
- Enter “infra” command to connect to the wireless network.
-
Example: infra
Step
7
Launch “HOME App" from iOS device and tap
Add
Accessory
.
Step
8
Select the Accessory to be added to the HomeKit.
