GE864-AUTO Hardware User Guide
1vv0300779 Rev.0 - 20/06/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 47 of 62
10.6 Using the Alarm Output GPIO6
The GPIO6 pad, when configured as Alarm Output, is controlled by the GE864-AUTO module and will
rise when the alarm starts and fall after the issue of a dedicated AT command.
This output can be used to power up the GE864-AUTO controlling microcontroller or application at the
alarm time, giving you the possibility to program a timely system wake-up to achieve some periodic
actions and completely turn off either the application and the GE864-AUTO during sleep periods,
dramatically reducing the sleep consumption to few
μ
A.
In battery-powered devices this feature will greatly improve the autonomy of the device.
NOTE: During RESET the line is set to HIGH logic level.
10.7 Using the Buzzer Output GPIO7
The GPIO7 pad, when configured as Buzzer Output, is controlled by the GE864-AUTO module and
will drive with appropriate square waves a Buzzer driver.
This permits to your application to easily implement Buzzer feature with ringing tones or melody
played at the call incoming, tone playing on SMS incoming or simply playing a tone or melody when
needed by your application.
A sample interface scheme is included below to give you an idea of how to interface a Buzzer to the
GPIO7:
