LET´S START RECORDING!
The Universal MK2 is ready to connect to your (1) microphone and recorder
(supplying XLR and +48v Phantom Power) straight out of the box - and you
don´t need any extra cables or batteries. The complete assembling procedure is
done within minutes, and you don´t need to perform any of the installation setup
by using tools or such. If you wish to bring several different microphones, you
may easily switch between them, on location, in matter of seconds, after some
training.
When using the
Telinga V2 Foldable Dish
the complete kit is very lightweight
and easily packed inside the green
Telinga
Soft Case
for traveling (less then
1.2 kg / 2.5 Lbs)
To start recording simply connect the Universal MK2 handle male XLR connector
from the bottom of the handle cable - to the XLR female connector input of your
recorder
. From the top of your Universal MK2 handle – connect the other end of
the handle cable (the XLR female connector) to the
microphone
male XLR
connector - with the cable running thru the Zeppelin holder. Make sure your
recorders
Phantom Power (+48v) is turned ON
.
Adjust the cable length accordingly, place and secure the gray "stopper" located
at the handle (if necessary) inside the gray tube.
Make sure everything is
fastened and secured correctly!
This to make sure you will have minimum
handling noise while recording and moving the parabola.
BELOW:
USING AN
OMNI
(LONGER LENGTH) MICROPHONE
FORWARD
SUCH AS SENNHEISER ME-62 /K6
Soft Case
Telinga
(optional) for traveling
(less then 1.2 kg / 2.5 Lbs)
and easily packed inside the green
Complete with the
Telinga (V2) Foldable Dish
the Universal kit is very lightweight
from the bottom of the handle wire - to the XLR female connector input of your
. From the top of your Universal MK2 handle – connect the other end of
connector - with the wire running thru the Zeppelin holder. Make sure your
Phantom Power (+48v) is turned ON
the handles wire (the XLR female connector) to the
microphone
male XLR
Adjust the length accordingly, place and secure the gray "stopper" located
SUCH AS SENNHEISER ME-62 /K6 OR SCHOEPS COLETTE / CMC SERIES
OMNI (or similiar).
fastened and secured correctly! This to make sure you will have minimum
handling noise while recording and moving the parabola.
Make sure everything is
at the handle (if necessary) inside the gray tube.
