4
General aspects:
Your STD35 can basically be configured in 2 ways:
1. Configuration-Call („easy-setup“)
In factory status the STD35 can be configured by a call within the first 3 minutes after connecting to the supply
voltage. In this case is „logging“ the phone number, from which this call has been made (supposing, that this
number is transmitted), and will report future event to this phone number.
You can switch by a call from this phone, from now on known to the STD35, also one of the relays.
The total STD35 can so be configured by call, in which it is remembering the phone number, for simple
applications. You don’t need a PC for it and don’t need to send SMS neither.
2. Configuration via SMS („professional setup“)
For more complexe tasks, e.g. the switching of the 5 outputs, the configuration of several persons being authorized
to switch or get event messages, the modification of the standard texts and a number of further parameters the
STD35 via SMS configured and controlled in a very flexible way.
Even the Reset into the factory status, e.g. to proceed for y new configuration call, is possible.
The configuration via SMS is described under „SMS commands“.
Configuration-Call
Please wait, until the GSM-LED has started to blink.
Then please call with the mobile phone, which is assigned to control the STD35, the phone number of the SIM card
being inside of the STD35. The call will be accepted by the STD35 and will be terminated a couple of seconds
later. As a control sign five signal tones will be sent via DTMF sequences! They can be heard during this call on
your mobile phone.
Due to this call the STD35 will be adjusted to the corresponding mobile phone, it will „log“ Your phone number, that
has been transmitted.
Therefore please take care, that your mobile phone will transmit the phone number, means the GSM
function „incognito“ or „private call“ has to be switched off
.
This is a configuration, that you can settle on your mobile phone, in which you put in the SIM card. (For testing this
feature you can call another mobile phone, there your phone number or name have to be displayed)
In case the STD35 e.g. due to being separated from the supply voltage, the STD35 will send, after the reapparition
of the supply voltage, automatically an SMS with the content „START-UP ALARM“ being sent to the configured
phone number.
Please consider: When the STD35 is not confirgured in factory status (neither by configurations call nor by
SMS), it will show this by alternative blinking of the LEDs „Input-Event“ and „Output-Event“. It is switching
off after 3 minutes autonomously, when not being configured within this time slot. A renewed connecting
to the power supply will switch on the STD35 anew, and it is expecting again a configuration.
Usage
After being configured, the following functions of the STD35 will be at your disposition:
Switching per call
Please call, after made configuration, the phone number of the SIM card being inside of the STD35.
Please take
care, that your mobile phone is transmitting the phone number
. (see as well „configuration call“). The relay 1
will then, depending on the configuration, switch for a certain time (factory status: 1 sec). The relays-status-LED
„Output-Event“ is on during this period.
Launch an Alarm SMS
Put for 1 second (Factory configuration) a voltage of 12V at one of the inputs, consider the polarization! Then an
alarm SMS will be sent to your mobile phone. The LED „input event“ is shortly flashing-up, when you put the
voltage to the STD35.
Sending SMS commands
Your STD35 can launch switching processes as well as be configured via an SMS, that you send to it.
The Format of the Configuration SMS:
To protect your STD35 against not authorized access, each of the configuration SMS to the STD35 has to begin
with a 4 digit password. The factory default provides the last 4 digits of the IMEI number for it! Your IMEI number is
visible on the GSM module:
