56044203
24 HOUR
ZONE (
N.C.)
TE
LC
O D
IA
LE
R
24 HO
UR ZON
E (N.O.)
TEL
CO
DIA
LE
R 1
TE
LCO
D
IAL
ER 2
Telguard TG-7 Series
QUICK INSTALLATION GUIDE [SOLE PATH]
Installation Summary
There are seven steps in installing Telguard properly.
IF YOU DO NOT
PROCEED IN THE ORDER AND MANNER PRESCRIBED, YOU MAY NOT
COMPLETE THE INSTALLATION IN THE TIME ALLOCATED.
S
TEP
1:
R
EGISTER FOR
C
ELLULAR
S
ERVICE
Register the unit online through
www.telguardonline.com
, by completing the
Online Registration Form at
www.Telguard.com
. Telular requires this information
to register and activate the unit.
S
TEP
2:
L
OCATE
U
NIT AND
M
EASURE
S
IGNAL
S
TRENGTH
(RSSI)
First, you will be confirming that Telguard has adequate cellular signal strength. Press the LED/RSSI
Mode Toggle button one time, LEDs will now indicate signal strength. Minimum recommended is 3 (3
on solid). Press the LED/RSSI Mode Toggle button a second time to exit RSSI mode.
S
TEP
3:
C
ONFIGURE
A
LARM
P
ANEL FOR
S
OLE
P
ATH
C
ONNECTION
Fire panels are typically provided with two Telco connections. Because the TG-7 provides a single
connection, the panel must be set up accordingly. The first method of installation is to configure the
panel to disable the second Telco connection. If this is not an option due to panel limitations, it is
possible to splice both TIP and RING connections from the panel into the single jack of the
Telguard. The TG-7 is capable of providing dial tone to both Telco connections.
S
TEP
4:
P
ROGRAM
,
A
CTIVATE
&
T
RANSMIT
P
ANEL
A
LARMS OVER THE
C
ELLULAR
R
ADIO
N
ETWORK
Program the TG-7 for Sole Path communication. You may do this by setting Memory Location 831
to a value of 3, using a butt-set. (See programming guide on reverse). LED 3 will be off when idle,
if successful. Next, connect the alarm panel's digital dialer output to Telguard and verify that alarm
signals can be reliably sent through Telguard over cellular to the central station digital receiver. A
minimum of two alarm signals must be transmitted.
Activation is confirmed when LED 1 is
illuminated.
(NOTE:
THE FIRST ALARM WILL ACTIVATE THE UNIT AT THE
T
ELULAR
C
OMMUNICATION
C
ENTER
,
IT WILL NOT GO TO THE
C
ENTRAL
S
TATION
,
ALL SIGNALS AFTER THE FIRST ARE
SENT TO THE
C
ENTRAL
S
TATION
)
S
TEP
5:
C
ONNECT
S
UPERVISORY
T
RIP
O
UTPUTS
Next, you will wire Telguard's supervisory trip outputs to the alarm panel and then test.
S
TEP
6:
C
ONNECT
T
RIP
I
NPUT
(
OPTIONAL
)
Optionally, you can wire an external relay input to the trip input lead and ground, and test.
S
TEP
7:
C
OMPLETE THE
I
NSTALLATION
Your last step will be to attach earth ground, and permanently mount the unit.
