56044203
Telguard TG-7 Series
QUICK INSTALLATION GUIDE [BACKUP MODE]
Installation Summary
There are seven steps in installing Telguard properly.
IF YOU DO NOT
PROCEED IN THE ORDER AND MANNER PRESCRIBED, YOU MAY
NOT COMPLETE THE INSTALLATION IN THE TIME ALLOCATED.
S
TEP
1:
R
EGISTER FOR
C
ELLULAR
S
ERVICE
Register the unit online through
www.telguardonline.com
, by completing the
Online Registration Form at
www.Telguard.com
. Telular requires this
information to activate the unit.
S
TEP
2:
L
OCATE
U
NIT AND
M
EASURE
S
IGNAL
S
TRENGTH
(RSSI)
First, you will be confirming that Telguard has adequate cellular signal strength. Press the
LED/RSSI Mode Toggle button one time, LEDs will now indicate signal strength. Minimum
recommended is 2
½ (2
on solid and the third flashing). Press the LED/RSSI Mode Toggle
button a second time to exit RSSI mode.
S
TEP
3:
T
RANSMIT
P
ANEL
A
LARMS OVER THE
T
ELCO
C
ONNECTION
Next, you will verify that the alarm panel is programmed properly. This step is important to verify
that the alarm panel is programmed with valid account code and central station information
before transmitting signals through the cellular network.
S
TEP
4:
P
ROGRAM
,
A
CTIVATE
&
T
RANSMIT
P
ANEL
A
LARMS OVER THE
C
ELLULAR
R
ADIO
N
ETWORK
Next, you will be connecting the alarm panel's digital dialer output to Telguard and verifying that
alarm signals can be reliably sent through Telguard over cellular to the central station digital
receiver. The incoming Telco line is
not
connected to Telguard during this step. A minimum of
two alarm signals must be transmitted. Activation is confirmed when LED 1 is illuminated.
(NOTE:
THE FIRST ALARM WILL ACTIVATE THE UNIT AT THE
T
ELULAR
C
OMMUNICATION
C
ENTER
,
IT WILL NOT GO TO THE
C
ENTRAL
S
TATION
,
ALL SIGNALS AFTER THE FIRST ARE
SENT TO THE
C
ENTRAL
S
TATION
)
S
TEP
5:
C
ONNECT
S
UPERVISORY
T
RIP
O
UTPUTS
Next, you will wire Telguard's supervisory trip outputs to the alarm panel and then test.
S
TEP
6:
C
ONNECT
T
RIP
I
NPUT
(
OPTIONAL
)
Optionally, you can wire an external relay input to the trip input lead and ground, and test.
S
TEP
7:
C
OMPLETE THE
I
NSTALLATION
Your last step will be to attach earth ground, reconnect Telco, and permanently mount the unit.
