TESTING THE SYSTEM
PRE WALK-THRU CHECKLIST
Following the instructions fully to this point
you have successfully completed the follow-
ing checklist:
Located the Transmitter properly.
Connected power to the TT-44
Transmitter.
Connected the antenna to the TT-44
Transmitter.
Connected your Intercom to your
transmitter.
Installed the batteries in the TR-34
Set the Transmitter Audio Gain(s)
If you missed any of the above instructions,
go back and complete that instruction before
going on.
SYSTEM WALK-THRU
Now that you have successfully “set up” your
Telex Wireless System and turned on your
sound equipment, you are ready to test the
overall performance by “walking” the Telex
receiver through the areas in which you will
be using it.
The “system walk-thru” can detect the follow-
ing problems:
·
Weak signal strength caused by:
·
Power Transmitter location
·
RF “Trouble Spots”
·
Operating
distance
beyond
system
capability
·
Malfunctioning system.
·
Mistuned Receiver
Under normal conditions the AUDIO LEVEL
Meter, located on the front panel of the
TT-44, should show a reading in the -10 to 0
(green) range with occa3 peaks (red).
Avoid +6 peaks as these will result in dis-
torted audio at the receiver.
See “SETTING SYSTEM GAIN”.
-12-
