Telex Audiocom PS-2001L, Руководство пользователя

Страница: 17 / 18

13
Power-Up Check
1.
Plug in any DC wallpacks that are being using with
individual intercom stations.
NOTE : If you plug in DC wallpacks after applying power to
the PS2001L or SPS-2001, you may get an overload
indication. This is because the stations that are being
powered by wallpacks will draw current from the units until
their own DC wallpack supplies are connected. To correct
the problem, plug in the DC wallpacks.
2.
Plug in the AC power cords for any connected PS-
2001L or SPS-2001 Power Supplies. The channel
status indicators should be green.
3.
If a channel status indicator turns red during
operation, locate the short or overload that is
causing the problem. Once the short or overload is
corrected, the Power Supply should reset itself and
the overload indication should go away.
Specifications
General
Input Power Requirements
100 to 240 VAC, 50/60 Hz
Current Draw
750mA maximum (SPS-2001)
700mA maximum (PS-2001L)
Output Power (each channel)
24 ±1 VDC, 1 Amp per channel
Dimensions
1.75” (44.5 mm) high x 8.25” (209.5mm) wide x 10.31” (261.9mm) deep
Weight
approximately 2.5 lb. (1.13 kg.)
Environmental Requirements
Storage:
-20° C to 80° C, 0% to 95% humidity, non-condensing
Operating:
0° C to 50° C, 0% to 95% humidity, non-condensing
Intercom Channels (General)
Connector Type:
One XLR-3M audio connector for each channel. Pin-out depends on setting
of BAL/UNBAL switch for balanced or unbalanced operation as defined
below:
Balanced Mode (set to BAL position)
Line Terminating Impedance: 300 ohms ±10%
Connector Pinout
Pin 1 Common (audio and DC return)
Pin 2 Full-duplex, balanced intercom audio and +24 VDC output
Pin 3 Full-duplex, balanced intercom audio and +24 VDC output
Unbalanced Mode (set to UNBAL position)
Line Terminating Impedance: 200 ohms ±10%
Connector Pin-out:
Pin 1 Common (audio and DC return)
Pin 2 +30VDC ±1VDC
Pin 3 Full-duplex, unbalanced intercom audio high
Speaker Inputs (SPS-2001 only)
Type:
RCA Phone Jack
Tip: S Input
Sleeve: Speaker - Input
Approvals
UL, CUL, CE