29
-
Lo (loopback): a dummy network in which one PC acts like a
network, necessary for certain software programs.
3.8.2 Static Routing
In the web configuration interface, click Routing Setting -> Static Routing in the left menu to build
static routes in the router. A static route is a pre-configured path through which the network
information shall travel to reach a specific host or network. The configuration interface will show as
below.
Follow the instructions below to set up a static route:
1) Select an ID for the static route in the field of Select.
2) Enter the destination IP address for the static route in the field of Dest Address.
3) Enter the subnet mask for the static route in the field of Dest Netmask.
4) Enter the IP address of next hop in the field of Next Hop Address.
5) Click the Save Settings button to make your settings take effect.
3.9 System Tools
In the web configuration interface, click System Tools in the left menu to check the current list of
static routes in the router. There are 6 sub-menus: System Time, Backup Setting, Firmware Upgrade,
Reboot to Default, and Password.
3.9.1 System Time
In the web configuration interface, click System Tools -> System Time in the left menu to check or
configure the system time on the router. The configuration interface will show as below. You shall
enter the values as per the following description and then click the Save Settings button.
The time zone is selected by the NTP (Network Time Protocol) and the router can also automatically
adjust for daylight saving time.
TeleWins(HK).,Co.LTD
