Televes 564980, Руководство пользователя

Страница: 13 / 28

EN
13
5.1. Main Menu
To switch between A and B modules of the DUAL
unit, keep pressed the button until the A/B
indication stars to flash in the upper left corner of
the display. Then use buttons and to select de
desired module.
In both modules A and B, parameters changed
are updated instantly; but in order to keep these
operating parameters it will be necessary to save
them before elapse 30 sec from the last change.
By short presses on the button , you can move
through the available menus.
If it has been chosen
converter mode , it will be
displayed the sequence Output menu => Input
menu, and so on.
In the case of being chosen
amplifier mode
, there
is only one menu since both input and output
channels are the same.
Remark 1
: Depending on how the processor is
programmed (this is done accessing the
extended menu, press button twice and
then, using buttons or , select mode
of operation) may function as amplifier
(input frequency equal to output
frequency) or converter (input frequency
is not equal to output frequency).
If the processor is programmed to operate
as an Amplifier there is only one setup
menu; and if it is programmed to operate
as a
Converter
, there will be two setup
menus: output and input.
5. - Instructions for use
Insert the programmer into the corresponding
connector (“PRGM socket”) of the unit. Then
the unit sends the parameters with what it
was previously configured (frequency, output
channels, input channels, output levels, ...) and a
new configuration process can be carried out.
The first item displayed is the version of the
Programmer firmware:
Next it shows the firmware version of the DUAL
A/D CHANNEL PROCESSOR unit:
Finally, it will be displayed the first device
configuration menu, that is the one corresponding
with its output menu.
Remark 2
: To change the menu language before
starting the device configuration, you
must access the “Language” menu.
To do so, press button (long press) to
access the Extended menu, press button
six times in a row, and then, using
buttons or , select the language.
Finally press button (long press) to
save changes. For more information,
see paragraph “Extended Menu” =>
“Language Selection Menu”.
a. Output menu
This menu allows to select:
• Output channel
, in both channel and
frequency modes.
• Output frequency offset (in case of digital
channel mode).
• Output level
.
The contents of the output menu depends on
how the unit has been programmed the last time
(frequency or channel mode, analog or digital
mode; options available in the extended menu).