4
/
33
SAFE OPERATION
To ensure that the Telethings LoRa Node device is reliable, the following conditions must be
met:
-
Do not install the device close to running water, do not wash it with water and other
liquids!
-
Do not install the device on unstable and vibrating surfaces, in order to prevent the
unit from falling down!
-
Do not install the device on metal surfaces in order to prevent the device from being
struck!
-
Protect the device from impacts, strong shaking and mechanical damage!
-
Do not manipulate with metal objects and utensils inside device while the device is
plugged into power in order to avoid electric shock!
-
Place of installation should not be exposed directly to the source of heat / cold and
strong light!
-
Turn on the adapter of the device to the 110-240 V and 50 / 60Hz frequency electrical
outlet. Prior to switching the adapter on or off, it is necessary to switch off the main
switch.
-
The manufacturer will not be responsible for the correct and safe operation of the
device if another network adapter is used.
-
Clean the device when disconnected, do not use chemical aggressive agents!
-
The appliance must only be opened and repaired by a qualified service engineer,
authorized by the manufacturer!
-
Disconnect the device from the network and send it to an authorized service facility
in case of a leak with a liquid, damage or incorrect operation!
-
Operation with the device can only be resumed after the malfunction has been
removed!
Do not install the device at a temperature below -20 ° C and higher than + 50 ° C, as correct
operation is not guaranteed.
ENVIRONMENTAL PROTECTION
The symbol on the back of the case, crossed garbage bin, means
that this product cannot be disposed with household waste. To
protect the environment and human health please separate this
product from other waste and recycle it. For further information,
contact your local government or product supplier.
It is forbidden to dispose old devices with mixed waste.
Содержание LoRa Node
Страница 11: ...10 33 Figure 3 Solder the coaxial cable for antenna Figure 4 Solder wires on GND pin i VDD pins 1 VDD 2 GND...
Страница 18: ...17 33 Figure 13 Step 2 Selecting STM32L071KB for hardware settings...
Страница 19: ...18 33 Figure 14 Step 3 Selecting software settings Figure15 Step 4 Selecting hardware debug settings...
Страница 21: ...20 33 Figure 19 Add include path n every new added folder Figure 20 Confirm adding include path for folder...
