12
/
33
Figure 6. Wire connection between TTL and Telethings LoRa Node
SOFTWARE PREPARATION
The following step is installation of an application through which commands will be
sent to the node and monitor the responses to the commands, or their actions. There are
several applications that can serve for these purposes, but we opted for Termite v3.1. Given
that this application is selected only for the purpose of testing nodes, i.e. to show how nodes
communicate over UART, installation of the aforementioned will not be explained, but special
attention will be payed to its settings.
After installation of console application such as Termite, connect the node and TTL as
shown on the Figure 5., and insert the TTL into the USB port of your computer.
To check which COM port is connected to TTL, Device Manager should be opened.
(Figure 6.)
Содержание LoRa Node
Страница 11: ...10 33 Figure 3 Solder the coaxial cable for antenna Figure 4 Solder wires on GND pin i VDD pins 1 VDD 2 GND...
Страница 18: ...17 33 Figure 13 Step 2 Selecting STM32L071KB for hardware settings...
Страница 19: ...18 33 Figure 14 Step 3 Selecting software settings Figure15 Step 4 Selecting hardware debug settings...
Страница 21: ...20 33 Figure 19 Add include path n every new added folder Figure 20 Confirm adding include path for folder...
