Teletek electronics LCD 63VG, Руководство пользователя

Страница: 20 / 28

20 LCD63VG Keypad User Manual
The number of the zone(s) that are bypassed
are replaced with a symbol on the LCD.
The symbol indicates the system arm-
ing mode.
After any of the procedures described above,
short beeps and blinking symbol on the
LCD indicate the exit time and the user is
required to leave the zone. Ten seconds be-
fore the exit time is over beeps frequency is
increased.
Instant
Instant arming means the user is allowed to
stay in certain zone(s), but the entrance zone
is secured. The difference with the stay arm-
ing is that intrusion into the entrance zone im-
mediately starts the alarm.
Instant stay arming key sequence:
Fast instant stay arming key sequence:
LCD displays:
The number of the zone(s) that are bypassed
are replaced with a symbol on the LCD.
The
symbol on the LCD indicates the sys-
tem is armed.
The symbol indicates the system arm-
ing mode.
Voice Messages in Arming Mode
With all arming modes, exept
Instant,
after
exit time starts running, the “ Please leave the
premises ” voice message will sound every
5 seconds. The buzzer will indicate that exit
time is running. Ten seconds before exit time
is over, beep frequency will increase.
After arming, the “
System is armed ” message
will be repetaed twice.
In the events of AC loss and low battery, the
“ AC power is lost ” or “ Battery discharged ”
messages will sound correspondigly 3 times
every 5 seconds when arming is attempted.
Panic
Pressing and holding sends
alarm signal.
Disarming
Coming into the entrance zone, the user is
required to enter a personal code:
A continuous beep indicates the entrance
time. The voice messages “ System is armed ”
and “ Please, enter your code to disarm ” will
sound on every 5 seconds.
After a valid code has been entered, the mes-
sage “ System is disarmed ” will be repeated
twice.
If no valid code has been entered during en-
try time, the “ System is armed ” message will
sound.
CODE
+
CODE