INSTALLATION
Quick Instructions
Install the unit into a
DVX002
-installation frame
equipped with a
DVP
power supply.
The rack must have a unique bus address assigned.
Switch on the system power and see that the “
M
”, “
C
”
and “
V
” -indicators on the front panel of the unit are lit.
The “
M
” (=module) should lit green to show that
hardware is operating properly.
Connect either a CVBS video signal to the BNC
connector or a S-VIDEO signal to the mini-DIN
connector of the unit.
Connect the ATM network to port “
ATM
” in the
front panel.
Connect a PC (with the Commander software installed)
to the Control Bus (
DVX BUS
) using the
DVX021
connection cable.
Start Commander and select the unit to confi gure and
proceed by fi lling in the required parameters.
Alternatively, if the in-band management is operational
over the ATM network, this can be done remotely from a
control center.
Make sure that the unit is not indicating any alarms or
warnings (
Status page
). The “
M
”, “
C
” and “
V
” -indicators
on the front panel should now lit green.
1
2
3
4
5
6
7
2 INE1x1 Series User Manual rev001
