4. Remove the two bolts that were shipped
installed on the front of your 23” mounting
plate. Then, use those two bolts to attach the
monitor mounting plate you assembled in
step 3. Be sure to center the monitor plate on
the 23” plate.
6. Take the two silver hood rods and insert them into the red holding
blocks on the back side of the trapezoidal hood. These two rods then
slide into the two holes on either side of the monitor back bracket. You
may need to loosen the two small thumb screws in order to slide the
rods completely into the holes. Tighten to secure.
5. If your camera requires to be raised, you can now mount the 3” riser
block by using the mounting bolts provided. Be sure to use two bolts
when mounting to prevent the block from swiveling. Then mount ei-
ther the cameras quick release plate, or the camera itself, to the top of
the riser block using the bolts provided. See the photo for an example.
Note: Each camera/lens setup has different height requirements. If you
need to raise the prompter rig for any reason, you can remove the two red
pillar blocks and flip them to the top side of the 23” mounting plate.
Note: It may be easier to secure one rod first, instead of try-
ing to insert both simultaneously.
