TELES VoIP Box BRI Series, Справочное руководство

Страница: 89 / 226

5 Additional VoIP parameters
VoIPBox DSL / VoIPBox BRI – version 21.0.009 Page 89
This chapter contains additional configuration entries to
fine-tune communication with the VoIP peer.
You can enter the following additional parameters in the
route.cfg
to adjust the configuration for improved commu-
nication with the VoIP peer.
5.1 Signaling parameters
Table 5.1
→
list some often used protocol independent VoIP
parameter.
Table 5.1 Customized parameters: protocol-independent VoIP signaling (page 1 of 5)
Protocol-Independent VoIP Signaling Parameters
VoipComprMaster=<mode>
This parameter defines which side the first matching codec comes from:
Yes
: Default. Priority is determined by the order of the system’s parameter list.
No
: Priority is determined by the peer.
VoipConnectOnCallProc=<mode>
Enter Yes (default No) to change an H.323 Call Proceeding/Call Progress and Alert, or
a SIP 180 or 183, into an H.323 Connect or SIP 200 message. This parameter can be
used if an announcement that plays before the Connect requires a Connect on the
other side to put through the call.
VoipDad=<num>
The digits/numbers defined here will appear in front of the original DAD as described
for the parameter VoipOad below. If the parameter is to be valid in only one direction,
you must also set the parameter VoipDadIn or VoipDadOut.
VoipDadIn=<string>
Specifies that the parameter VoipDad is for incoming calls only. If this parameter is
not set (default), VoipDad will apply for both directions.
VoipDadOut=<string>
Specifies that the parameter VoipDad is for outgoing calls only. If this parameter is not
set (default), VoipDad will apply for both directions.
VoipDataBypassPayloadType=<num>
Defines the payload type for the RTP packets when the call is sent as a data call. De-
fault 96.
VoipEarlyT38=<mode>
Enter
yes
to enable T38 before the call has been connected. Enter
no
to enable T38
after the call has been connected. Default yes.