Important: Emergency Help System feature
Note:
The phone book allows you to enter, display, record the persons name and specify if this a
telephone no. that is to be called in the units Telemergency Emergency Help system.
It is important to note that any
telephone # entered that is less than 6 digits (including pauses area codes or any other digits will only be
called 1 time if the emergency help system is activated. (Ex. 911). The Emergency Help System when activated
will call all entered #s in the Emergency Help System 2 times, unless a called party stops the process or the
telephone # is less than 6 digits(including all pauses area codes etc.
To dial and check an entered and displayed emergency telephone number from the Phone Book
Memory:
1. Pick up the handset or press
SPEAKER
button (the speaker LED will light) and wait for a dial tone.
2. Press and release
CLIP
(Exit) button,
phone book icon is shown.
3. Scroll to desired tel. no. with
or
buttons until display with its
icon and location # is shown.
4. Press
OK
button, Unit will dial telephone no.
5. If you desire you can speak to called party and explain that you are adding their telephone number to
your Telemergency Emergency Help System.
IMPORTANT:
Follow all Cautions below if Emergency Help System is to be activated. If you are using
the Emergency Help System and wish to call “911” or other emergency services which have a dispatcher,
the following procedures should be followed. Note: Check with your local “911” and/or other emergency
services and verify the use of their no. in your area.
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO
EMERGENCY NUMBERS:
1. Remain on the line and briefly explain to the dispatcher the reason for the call.
2. Perform such activities in the off-peak hours, such as early morning or late evenings.
Caution - To ensure proper operation, this equipment must be installed according to the enclosed
installation instructions. To verify that the equipment is operating properly and can successfully report
an alarm, this equipment must be tested immediately after installation, and periodically thereafter,
according to the enclosed test instructions.
Caution - This equipment cannot report an alarm when other equipment (telephone, answering system,
computer modem, etc.) connected to the same phone line is in use
.
Important Information about ClearVoice 200B Emergency Help System:
Note: A tone dialing telephone is required for a called party(s) to be able to respond to a message
received from the Emergency Help System
.
1. If NO emergency numbers have been entered, the telephone will not dial any no. and just beep loudly
for 15 seconds continuously when the emergency (
) button on the telephone, is pressed and held
for more than 4 seconds or on the red button on CV112 dual pendant (standard on the ClearVoice
200B™) is pressed for 4 seconds. If red pendant button is pressed and held for 8 seconds or more
continuously, the emergency process will stop and reset.
2. It is important that the CV 114 pendant must be within the range of the telephone to activate the
emergency feature.
3. When the red key on the optional pendant (standard on the ClearVoice 200B™) is pressed and held
for 3-5 seconds and pendant is within the range of the unit , the LED on the pendant will begin flashing
to let user know that unit is activated and if the pendant is pressed for 8 seconds the LED will simply stay ON for
approximately five (5) seconds letting user know that the Emergency Help System is OFF and reset.
To activate the Emergency Help system is simple. Simply press and hold down red button until LED
flashes on the pendant. Then release button. This LED will stay lit for 15 seconds.
4. To stop the already activated emergency help system, turn off speakerphone by pressing the
17
Содержание ClearVoice 100 B
Страница 24: ......
