Telematrix Spectrum Plus SP550, Руководство пользователя

Страница: 14 / 67

14
Connecting the Handset Cord
A 10-foot modular coil handset cord is
provided. (Be sure that the wall/desk
elevation stand has not been attached).
To install the cord, simply plug the
short end of the handset cord into the
modular jack on the handset. The long
end of the handset cord plugs into the
jack labeled “Handset” located on the
bottom of the Spectrum PLUS
TM
base
unit. Place the line cord into the hand-
set coil cord channel located directly
below the jack.
Installing the Keycaps
Twenty-two (22) preprinted named
feature keycaps are provided to identify
the speed dial key.
There are eleven (11) clear keycaps
already installed. To install preprinted
keys, remove the clear keycap by
simply pulling up. Replace with the
preprinted keycaps or place hand
written paper index sheets under a
clear keycap. Program each speed dial
key for the specific function of the key.
There are four (4) additional clear keycaps and two (2) index sheets provided as
spares. Use these for your own personal speed dial identities. Write the speed dial
name on the blank speed dial index cards and insert into the blank keycaps. Place
the keycap on the correct memory speed dial location. (see index sheets provided
in box).
Handset C ord
PLASTIC KEYTOP
PLASTIC TOP CABINET
CLEAR "SNAP-ON" KEY CAP
PLASTIC TOP CABINET
OR SILK SCREEN KEY CAP
The twenty-two preprinted keycap names are below:
Call Fwd On Call Back Paging Skip Msg Information
Call Fwd Off Cancel Call Back Ring Again FF Msg 911
Transfer Call Park Save Msg Rew Msg
Conf Call Pick-up Del Msg Emergency
DND Group Call Pick-up Rpt Msg Help Desk
NOTE: For speed dial programming instructions,
see the section on “Programming Procedure For
Spectrum PLUS
tm
Speed Dial Features” in this
manual.