16
To Program Speed Dial Locations
1. Press and hold the “STORE” key. (figure 1).
2. Next, press the speed dial location key where
the desired location will be (figure 2).
3. Press
the
“STORE” key again (figure 3).
4. Using the dial pad, enter the number. Note that
the local area code is not required if AREA
CODE is pre-programmed into memory.
5. After entering the number, press the “STORE”
key. (figure 4).
6. Using the keypad, enter the name associated
with the number being programmed and include
the Flash, and/or Pause, when needed.
7. Press
the
“STORE” key to store the entry.
8. To program other speed dial locations, repeat 2
to 7.
9. To exit the program mode, press “DISC”.
Programming Procedure for Spectrum Plus
TM
Speed Dial Features
(Manual Entry of Characters)
The Spectrum PLUS
TM
Telephone has eleven (11) one-touch speed dial locations that are
convenient for dialing frequently used telephone numbers. This feature is under Adminis-
trative control so user changes do not occur.
•
Speed dial programming must be done with the telephone plugged into the telephone
line and power adapter.
•
Programming can be performed with the telephone on-hook only.
•
A maximum of 32-digits can be entered into ENTER NUMBER and 12-characters into
ENTER NAME.
ENTER NUMBER
ENTER NAME
Set up speed dial mem-
ory locations with name
and number entries.
Check verifies correct
entry.
ENTER ACCESS NO.
12/01
PM
12:00
M01 NO CONTENT
12/01
PM
12:00
ENTER NUMBER
12/01
PM
12:00
ENTER NAME
12/01
PM
12:00
Figure 2
Figure 3
Figure 4
Figure 1
Содержание Spectrum Plus LP550
Страница 2: ...This page is intentionally left blank...
Страница 6: ...TOP PANEL 6...
Страница 8: ...8 RIGHT SIDE LEFT SIDE REAR...