47
ENGLISH
1) Press the
key and if you hear “ANSWER ON, ANNOUNCEMENT1”, you are currently using
OGM1.
2) Press the
key again to switch to OGM 2, and you will here “ANSWER ON,
ANNOUNCEMENT 2”.
To play/pause/stop messages on TAM
When there are new messages, the display will show e.g.
01/02 MSGS
, which means you have
1 new message/2 messages altogether.
1. Press
to listen to messages and memos, press
▲
or
▼
key to adjust the playing volume.
The pause time maximum is one minute. If not quit from pause in one minute, then it will quit the
message plays after one minute automatically.
2. Press the
again to pause during a message.
3. Press
to stop the message playback.
To delete a message on TAM
Press the
DEL
while a message is playing. You will hear “MESSAGE DELETED” and the current
message will be deleted, and the next message will start to play if there are more messages.
To delete all messages on TAM
While a message is playing, press and hold
DEL
for 2 seconds at any time to delete all old
messages. Then announce “ALL MESSAGES DELETED”, and all old messages will be deleted.
Note:
You cannot delete New Messages, so you will have to start to play them before
trying to delete them.
To record a memo on TAM
Press and hold
MEMO
key to enter record a memo conveniently, Press
key to stop the
message record and back to idle mode.
Incoming Call Messages (ICM)
If the answering machine is ON and set for OGM1, when there is an incoming call, the answering
machine will answer it and play the OGM. Followed by a “beep”, the caller can then leave a
message of up to 2 minutes on the answering machine. The caller’s voice will also be played through
the loudspeaker to allow you to screen the call and decide if you want to leave the answering
machine to record the message, or if you want to talk to the caller directly.
1) You can use the corded handset, the speakerphone to intercept the call to speak to the caller
during ICM recording. Then the message that is currently being recorded will be saved as a new
message.
2) Recording will stop also if silence, busy tone or continuous tone is detected, and the message
will be saved.
Remote Control
If you are away from home, TAM can be accessed by remote control.
Use tone dialing to dial your numbers to access your answering machine from a remote location.
1) When you hear the OGM announcement, press * key, the answering machine will enter the
remote control state, and require to put in the 4-digit security code. The default security code
is “0000”.
2) If the security code is correct, you will hear a voice prompt telling you if you have any message,
and will automatically play new messages firstly if your answering machine has any new
messages. If there’re no new messages, it will play all messages on the answering machine.
3) When messages are being played,
Press 2 -- To delete a message.
Press 4 -- To skip back to the previous message.
Press 6 -- To skip to the next message
Press 5 -- To pause and restart the current message. The pause time maximum is one minute.
