46
ENGLISH
To set TAM voice language
Press
▼
key to move to
TAM VOICE
, press
MENU/OK
to enter. Press
▲
or
▼
to choose among
FRANCAIS
(French),
DEUTSCH
(German),
ENGLISH
and
ESPAÑOL
(Spanish), press
MENU/OK
to confirm.
To change security code (TAM PIN)
The security code is used to access the remote control, and is a 4-digit code. The default code is
“0000”.
Press
▼
key to move to
TAM PIN
, press
MENU/OK
to enter and the display will show the current
setting”0000”, use the keypad to enter the new security PIN code, press
MENU/OK
to confirm.
To reset TAM to default settings
You will restore the following settings after you select this command.
— Ring setting: 5
— TAM ON
— OGM 1
— Security code: 0000
— TAM alert: OFF
Press
▼
key to move to
TAM DEFAULT
, press
MENU/OK
and the display will show
PIN?
, enter the
PIN code using the keypad (default as 0000), then press
MENU/OK
to confirm. If the PIN code is
validated all TAM settings will be returned to the factory default.
Short-cut Keys for TAM Operation
Switching TAM on/off
¾
Switch TAM on to OGM 1 or OGM 2
1) In idle mode, when the display show
TAM OFF
, press and hold
for over 2 seconds to
switch
TAM ON
.
2) The display will show
OGM 1
, and announce “Answer ON, Announcement One”.
3) After this, the display will show the number of messages.
4) Press
briefly to switch between OGM1 and OGM2.
¾
Switch TAM off
If the TAM is already switched on, either with OGM1 or OGM2, press and hold
for 2 seconds to
switch the TAM off. Then the display will show
TAM OFF
.
To playback the OGM
In idle status, press the OGM briefly to listen to the current OGM (OGM1 or OGM2).
To record your outgoing message (OGM)
OGM is set as the default announcement when you set up the phone for the first time. You can
record your own personal announcement of up to 60 seconds for each OGM.
¾
To record OGM1
1) The pre-set announcement for OGM1 is “Sorry we cannot answer your call now, please leave
your message after the beep”.
2) First ensure OGM1 is set as the outgoing message. Then press and hold
OGM
, the display will
show “
OGM 1
” and announce “Please record new announcement after the beep”. You can start
speaking after a beep tone.
3) Press
to end the recording.
¾
To record OGM2
1) The pre-set announcement for OGM 2 is “Sorry we cannot answer your call now, please call
later”.
2) The unit will automatically switch to
OGM 2
to answer a call when the memory is full.
3) Ensure OGM 2 is set as the outgoing message. Repeat above sequence as OGM 1 to record the
OGM 2 announcement.
Switch between OGMS
When the TAM is switched ON you can select
OGM1
or
OGM2
.
