Telefunken TF-1596, Инструкция по эксплуатации

Страница: 4 / 16

Instruction manual
3
Important safeguards
•
The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual for future use.
• Do not hit or drop the unit
• Do not
e
xpose the unit to vibration, direct
sunlight, too high or low temperatures or
humidity.
• Do not disassemble the unit yourselves
Refer servicing to qualified service personnel
All the illustrations in this manual are
schematic images, which may differ from
actual objects.
Power supply
Battery operation
• Insert 1 CR2032 batter y ( included)
to the terminals inside the battery
compartment according to the polarity marks
(+ and -). Your set will have a limited
operation from the battery supply, but there is
now the advantage that, in case of a mains
current failure or power outage, your clock will
continue to work. The clock display will not
light up, the clock time and alarm setting will
be held in the clock memory by the battery
back-up system.
This enables you to move the set from place
to place without re-setting the clock every time.
The battery back-up system is only meant to
be used for short-term power failures. For
longer durations the batter
y may become
exhausted or there may be some deviation in
accuracy.
•
When the batter y is exhausted, it
check that the voltage indicated on the rating
label corresponds to the mains voltage in your
location.
plug in the appliance for the first time and when
there has been a power failure.
General operations
Setting time
• You have to set the clock time when you
approximately 40-50 cm from your head, for
example, on a bedside table.
Placement
• Place the device close to you,
should be removed from the set to prevent
leakage. If you do not wish to take advantage
of the battery back-up system, your set will
work normally without batteries. However, if
disconnected from the mains, the clock
figures will flash when the mains are
reconnected and you must re-set the clock.
DС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
• Plug the supplied AC/DC power
adaptor into the DC adaptor input on the back
of the unit. Connect the power cord to the AC
household main outlet. Make sure the voltage
is compatible.
• Always remember to disconnect
the power cord from the main supply before
disconnecting it from the unit.
• When the time starts to blink touch
to adjust it. Touch to confirm. Setting
will be canceled if no button is pressed in
10 seconds.
modes by pressing . When the 12-hour
format is selected, AM or PM will be displayed.
• Choose between a 12-hour and 24-hour
time display: Low - High - Off.
• Press to adjust the brightness of
automatically change to high brightness
when you change any settings, and then
revert back to low intensity after 5 seconds.
• When low brightness is selected, it will
Light
• Press once to switch on white
light and use it as a bedside lamp. You can
adjust the light intensity by touching
,
there are 10 levels in total.
• Change current time by pressing and
holding for 3 seconds until the time starts
to blink. Touch to adjust it. Touch to
confirm. Setting will be canceled if no button is
pressed in 10 seconds.