Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 31
System Configuration and Installation
Transmitter Installation
Step 1:
Plug the RJ-45 network cable into the socket on the switch's rear panel.
Afterwards, plug the other end of the network cable into the socket on the
VRB
's
rear panel.
Step 2:
Plug the switch power cable into the hub power connector. At the same time, plug
the switch power supply into a wall let and power on the switch.
Step 3:
Plug one end of the
BNC
cable into the
VIDEO OUTPUT
of the
CCD
camera, then
plug the other end to the
VRB
's
VIDEO INPUT
connector (
CH1
preferred)
Step 4:
If more than one camera are installed, plug the
BNC
cables to the
Eye
III+
Video Recording Transmitter
CH2
to
CH4/8/16
sequentially.
Step 5:
Connect alarm sensor to the corresponding pins of the
ALARM & SWITCH
port, if
necessary (For the pin assignment of the ALARM port, please refer to section 2,
Alarm Definition
).
Step 6:
Plug the round end of the A.C. adaptor into the socket marked POWER on the
VRB
. (Note: please use the 12V D.C. power adaptor supplied by
Eye
Group
only)
Step 7:
Plug the A.C. adapter to A.C. power source to power on the
VRB
. The
VRB
's LED
on the front Panel and the LINK LED on the rear panel should light up.
Step 8:
You may now use the
Eye
III+
Reception Software
to connect to the
transmitter. For the instructions of using the software, please refer to the
Eye
III+
Reception Software
User Guide
.
Eye
III+
Video Recording Transmitter
Support 4 Video
Sources
BNC Cable
RJ-45 Network Cable
