Quick Start 7
Store/Recall ----Store and Recall
Used to store/recall the instrument’s setup or arbitrary waveform data edited by
users.
•
Can be used to perform general file operations.
•
In addition to the built-in nonvolatile memory (C disk), an external USB drive (D
disk) can be used to store data.
•
The corresponding backlight will turn on when this function is selected.
10.Waveform Selection Key
Waveforms ---- Sine
Provides sine wave output which ranges from 1 μHz to 40 MHz, 80 MHz or 120
MHz, depending on the model.
•
The
Waveforms
backlight will turn on when this function is selected.
•
The sine wave “Frequency/Period”, “Amplitude/High level”, “Offset/Low level” and
“Phase” can be adjusted.
Waveforms ---- Square
Provides square wave output which ranges from 1 μHz to 25 MHz.
•
The Waveforms backlight will turn on when this function is selected.
•
The square wave “Frequency/Period”, “Amplitude/High level”, “Offset/Low level”,
“Phase” and “Duty” can be adjusted.
Waveforms ---- Ramp
Provides ramp waveform output which ranges from 1 μHz to 1 MHz.
•
The Waveforms backlight will turn on when this function is selected.
•
The ramp waveform “Frequency/Period”, “Amplitude/High level”, “Offset/Low
level”, “Phase” and “Symmetry” can be adjusted.
Waveforms ---- Pulse
Provides pulse waveform output which ranges from 1 μHz to 25 MHz.
• The Waveforms backlight will turn on when this function is selected.
• The pulse waveform “Frequency/Period”, “Amplitude/High level”, “Offset/Low level”,
“Pulse width/Duty”, “Rise/Fall” and “Delay” can be adjusted.
