6
6
Turn the rotor clockwise as far as it will go.
7
Finish sliding the cable around the rotor on the back of the autosampler.
Loosen the thumbscrew on the rotor to allow the cable to pass through the
clamp, with about 2 mm of cable extending past the clamp.
Figure 8
Position of Cable on Rotor
8
Verify that there is a small gap between the Z-axis slider and cap at the top of
the Z-drive (approximately 1-3 mm). Adjust the cable a bit if necessary.
Figure 9
Z-Drive at Top Position With Gap
9
Hold the cable flat against the rotor and secure the cable by tightening
thumbscrew on the rotor. The thumbscrew should be as tight as possible using
just your fingers.
