Teledyne 2103Ci, Инструкция по установке и эксплуатации, Страница: 17 / 74

2103 Modem Module
Section 2 Preparation and Installation
2-5
If Problems Arise: If any of your telephone equipment is not
operating properly, you should immediately remove it from your
telephone line, as it may cause harm to the telephone network.
If the telephone company notes a problem, they may temporar-
ily discontinue service. When practical, they will notify you in
advance of this disconnection. If advance notice is not feasible,
you will be notified as soon as possible. When you are notified,
you will be given the opportunity to correct the problem and will
be informed of your right to file a complaint with the FCC. Con-
tact your local telephone service provider if you have any ques-
tions about your phone line.
In the event repairs are needed on the 2103 Modem, they
should be performed by Teledyne Isco or its authorized repre-
sentative. For information, contact the Teledyne Isco Customer
Service Department at (866) 298-6174 or (402) 464-0231.
2.3.1 Modem Cable
Connection
After you have installed the 2103 on the stack, you need to attach
the modem cable so the module can be connected to a phone line.
Remove the connector cap from the 5-pin circular modem cable
connector on the right hand side of the 2103. Attach the modem
cable to the connector (Figure 2-1), and then connect the other
end of the modem cable to a standard telephone jack (USOC
RJ-11C).
Figure 2-2 Connecting the Modem Cable
2.3.2 Connection Without
the Modem Cable
If desired, the 2103 can be connected to a standard telephone line
by attaching the telephone line cable to a connector that mates
with the 2103’s 5-pin circular modem cable connector (Figure
2-2). Be sure that you have a water tight seal on your wire con-
nections.