Teledyne TapTone T4000 APX, Руководство по установке

Страница: 50 / 54

M-412-073 Appendix B: Technical Specifications
TELEDYNE TAPTONE
43
Appendix B
– Technical Specifications
B.1 Electronic Control Box Specifications
General Specifications
Electrical:
Control Box: 100-120VAC 47 - 85 Hz, single phase, 275 watts
Or 200-240VAC 47-85Hz, single phase, 275 watts
Air: 206.8 kPa - 1034.2 kPa, 2832 cm
3
/sec (30
– 150 psi., 6 cfm.)
Room Temperature: 0º - 50º C (32º to 122º F)
Humidity: 0 - 90%, non-condensing
Altitude: Sea level to 3,035 m (10,000 feet)
Control Enclosure
Dimensions:
41 cm high x 41 cm wide x 18 cm deep (16 in. x 16 in. x 7 in.).
Construction: Control enclosure with junction box
Material: Stainless steel, NEMA 4X, IP65 rated
Wash Down: Low-pressure water
Mounting: Angled pedestal stand, stainless steel
HMI: Watertight LCD touch screen 25.4 cm (10 in.)
Reject Lamp: 24 VDC, 6.5 watt, orange lens, 1/2 second pulse per reject
Reject Signal: 24 VDC, 1 amp, variable pulse width and delay time
Communications: Molex watertight Ethernet socket RJ-45
Shaft Encoder
Resolution:
2500 pulses / revolution
Construction: Stainless Steel or Aluminum, NEMA 4X, IP65
Wash Down: Low-pressure water
Cable Type: 4 conductor, 20 AWG shielded
Cable Diameter: 4.62 mm (0.182 in.)
Cable Length: 7.62 m (25 ft.)
Supply Power: 5-26VDC
Signal Output: 5-26VDC, two channels, input voltage follower
Trigger Sensors
Photo Beams:
Thru-beam fiber optic, high speed, 10-30 VDC pnp output
I/O Interface Board
Input Modules:
Four solid state, 3-24 VDC
Output Module: Four solid state, 0-24 VDC @ 3.5 amps, normally open