REQUIREMENTS OF PART 68 - FCC RULES
This device has been granted a registration number by the Federal Communications Commission, under
Part 68 rules and regulations for direct connection to the telephone lines. In order to comply with these
FCC rules, the following instructions must be carefully read and applicable portions followed completely:
1.
Direct connection to the telephone lines may be made only through the standard modular cord fu
nished, to the utility installed jack. No connection may be made to party or coin phone lines. On the
bottom of the phone is a label that contains among other information, the FCC Registration Number
and the Ringer Equivalence number (REN) for this equipment. If requested this information must be
provided to the telephone company. The USOC Jack for this equipment is RJ11C.
2.
The telephone company, under certain circumstances, may temporarily discontinue and make
changes in facilities and services which may affect the operation of the users' equipment: however,
the user shall be given adequate notice in writing to allow the user to maintain uninterrupted service.
3.
In certain circumstances, it may be necessary for the telephone company to request information from
you concerning the equipment which you have connected to your telephone line. Upon request of
the telephone company, provide the FCC registration number and the ringer equivalence number of
the equipment which is connected to your line; this information will be found on the device.
4.
If any of your telephone equipment is not operating properly, you should immediately remove it from
the telephone line. It may cause harm to the telephone network.
5.
If the telephone company notes a problem, they may temporarily discontinue service. When practi-
cal, they will notify you in advance disconnection. If advance notice is not feasible, the telephone
company must; promptly notify you of such temporary discontinuance; afford the opportunity to cor-
rect the condition; inform you of your rights to bring a complaint to the FCC under their rules.
6.
Repairs to the device may be made only by the manufacturer or an authorized service agency. This
applies at any time during and after warranty. If unauthorized repair is performed, registration, con-
nection to the telephone lines and remainder of warranty period all become null and void.
7.
This equipment is hearing aid compatible.
8.
This telephone must be connected behind a PBX.
REQUIREMENTS OF PART 15 - FCC RULES
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction, may cause harmful inter-
ference to radio communications. However, there is not a guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: -Move the telephone away from the receiver. -
Consult the dealer or an experienced radio/TV technician for help. Any changes made by the user not
approved by the manufacturer can void the user's authority to operate the telephone.
INDUSTRY OF CANADA REQUIREMENTS
NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equip-
ment meets certain telecommunications network protective operational and safety requirements as pre-
scribed in the appropriate Terminal Equipment Technical Requirements documents. The department does
not guarantee the equipment will operate to the users satisfaction. Before installing this equipment, users
should ensure that it is permissible to be connected to the facilities of the local telecommunications compa-
ny. The equipment must also be installed using an acceptable method of connection. The customer should
be aware that compliance with the above conditions may not prevent degradation of service in some situa-
tions. Repairs to certified equipment should be coordinated by a representative designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment. Users should ensure
for their own protection that the electrical ground connections of the power utility, telephone lines, and inter-
nal metallic water pipe systems, if present, are connected together. This precaustion may be particularly
important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the appropri-
ate electric inspection authority or electrician, as appropriate.
The Ringer Equivalence Number (REN) of this device is Z.
Notice: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of
the maximum number of terminals allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the requirement that the sum of the
Ringer Equivalence Numbers of all the devices does not exceed 5. This telephone connects to the tele-
phone network under the connecting arrangement code CA11A.
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS
BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS.
INCLUDING THE FOLLOWING:
1.
READ AND UNDERSTAND ALL INSTRUCTIONS.
2.
FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE PRODUCT.
3.
UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE CLEANING. DO NOT USE LIQUID
CLEANER OR AEROSOL CLEANERS. USE A DAMP CLOTH FOR CLEANING.
4.
DO NOT USE THIS PRODUCT NEAR WATER FOR EXAMPLE NEAR A BATHTUB, WASH BOWL,
KITCHEN SINK OR LAUNDRY TUB, IN A WET BASEMENT, OR NEAR A SWIMMING POOL.
5.
DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND OR TABLE. THE PRODUCT
MAY FALL, CAUSING SERIOUS DAMAGE TO THE PRODUCT.
6.
SLOTS AND OPENINGS IN THE CABINET AND THE BACK OF BOTTOM ARE PROVIDED FOR
VENTILATION, TO PROTECT IT FROM OVERHEATING, THESE OPENINGS MUST NOT BE
BLOCKED OR COVERED. THE OPENINGS SHOULD NEVER BE BLOCKED BY PLACING THE
PRODUCT ON THE BED, SOFA, RUG OR ANY OTHER SIMILAR SURFACE. THIS PRODUCT
SHOULD NEVER BE PLACED NEAR OR OVER A RADIATOR OR HEAT REGISTER. THIS PROD-
UCT SHOULD NOT BE PLACED IN A BUILT-IN INSTALLATION UNLESS PROPER VENTILATION
IS PROVIDED.
7.
NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCT THROUGH CABINET SLOTS AS
THEY MAY TOUCH DANGEROUS VOLTAGE POINTS OR SHORT OUT PARTS THAT COULD
RESULT IN A RISK OF FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY KIND ON
THE PRODUCT.
8.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT DISASSEMBLE THIS PRODUCT BUT TAKE
IT TO A QUALIFIED SERVICEMEN WHEN SOME SERVICE OR REPAIR WORK IS REQUIRED.
OPENING OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS VOLTAGES OR OTHER
RISKS. INCORRECT REASSEMBLE CAN CAUSE ELECTRIC SHOCK WHEN THE APPLIANCE IS
SUBSEQUENTLY USED.
9.
UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL UNDER THE FOLLOWING CONDITIONS.
· WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED
· IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT.
· IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER.
· IF THE PRODUCT DOES NOT OPERATE NORMALLY BY FOLLOWING THE OPERATING
INSTRUCTIONS. ADJUST ONLY THOSE CONTROLS THAT ARE COVERED BY THE OPERATING
INSTRUCTIONS BECAUSE IMPROPER ADJUSTMENT OF OTHER CONTROLS MAY RESULT IN
DAMAGE AND WILL OFTEN REQUIRE EXTENSIVE WORK BY A QUALIFIED TECHNICIAN TO
RESTORE THE PRODUCT TO NORMAL OPERATION.
· IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS BEEN DAMAGED.
· IF THE PRODUCT EXHIBIT A DISTINCT CHANGE IN PERFORMANCE.
10. AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE) DURING AN ELECTRICAL
STORM. THERE MAY BE A REMOTE RISK OF ELECTRIC SHOCK FROM LIGHTING.
11.
DO NOT USE THE TELEPHONE TO REPORT A GAS LEAK IN THE VICINITY OF THE LEAK. SAVE
THESE INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR REFERENCE
6
7
Содержание CL 2900 Series CL2905
Страница 1: ......
