TeleDart GmbH & Co. KG, Obere Heide 8, 67368 Westheim, Germany
Seite 5
27.06.2019
•
Loading of the dart syringe
Using the positioning pin first insert the syringe into the backside of the barrel and
make sure, that the flight stabilizer is completely inserted into the barrel. Put the barrel
onto the barrel retainer as far as it will go. The notch has to show exactly to the top!
•
The shooting
The applicator is now ready for shooting. The trigger safety can now be de-activated by
pulling the trigger safety bolt in shooting direction as far as it will go - until you can see
the red ring. Now fix your aim. Push the trigger in
one fast movement
to allow precise
shooting.
Immediately after shooting please activate the trigger safety by pushing the trigger
safety bolt inside as far as it will go. The red ring must dissappear again.
4. Care
The applicator can be cleaned with a moist cloth. Never use chemical cleansers or oil!
Regularely check, if there is dirt inside the barrel. If necessary brush it dry with the cleaning
brush (comes with the barrel). Don’t use chemical cleansers or oil.
Further care is not necessary.
5. Maintenance
Special maintenance is not necessary. If your barrel becomes difficult to fix, grease the
o-rings of the barrel retainer.
6. Storage
For storage and transportation all legal requirements must be complied with.
Always store the applicator with activated trigger safety and at a dry place.
CO2-cartridges can remain in the applicator.
If you have not used your applicator for a longer time, please check the function first.
7. Accessory Equipment
- Mounting rail
MSR
for red-dot sights
- Red-Dot Sight
OP2
- Laser Rangefinder
RF
(not mountable)
- Adaptor
AR45
for large CO2-cartridges 45gr
CO245
- Foot-airpump
FP
(
for RD206-CO2)
- CO2-Device
DOC
(
for RD206-AIR)
- Additional barrel
BAP11
(11mm),
BAP13
(13mm) or
BAP16
(16mm)
- Short barrel calibre 11mm (1-5cc); Length: 40cm
TeleDart GmbH & Co. KG
Westheim, November 1
st
, 2018
