User Manual — TeleCorder with UpCorder Software —
V 2.17-B-US
17
From the Port Activity window you can click
Configure
to launch the
Recorder Settings
window
for the multi-unit UpCorder software. Refer to the following screen image.
The
Configure Software, and/or Hardware unit(s)
window is used to change the software
settings that are stored in your computer. The hardware settings for each TeleCorder can also be
individually configured from this window. To check or change hardware settings for Unit 1, click on the
tab labeled
H/W Settings (Unit 1
)
, refer to the following screen image and
Section III. Using TeleCorder
in this manual. If more than one unit is connected to the PC, you will have a tab to check or change
hardware settings for each TeleCorder.
After making any changes to hardware settings, click the Write Hardware button to confirm any
changes, unplug the TeleCorder USB cable and re-connect, close software and re-load, check to confirm
that the desired changes have been locked into TeleCorder hardware settings and that the TeleCorder is
functioning as expected.
Note: External USB hubs can be troublesome, especially when turning the computer power OFF and
ON, and when removing and re-installing USB devices. Always check for proper operation after
making changes to TeleCorder hardware, and closing and opening UpCorder software.
