Teleco TY2/19D, Инструкция по эксплуатации

Страница: 10 / 44

8
Preparing your LED TV for use
How to set up the TV
Use an antenna cable to connect the RF signal to the LED TV RF IN terminal (refer to page 9).
Connect one end of the DC source unit to the back of the TV, and the other end of the DC source unit
to the power source.
Insert two AAA size batteries (supplied) in the remote control.
Step 1 Push and slide the back cover to open the
battery compartment of the remote control.
Step 2 Insert batteries. Make sure the (+) and (-) poles
of the batteries match the (+) and (-) terminals in the battery
compartment. Snap the cover back in place.
Do not clean the remote control with caustic cleaning agents (such as porcelain, stainless
steel, toilet, or oven cleaners etc.) as doing so may damage it.
Using the Remote Control properly
• Never mix used and new batteries in the device.
• Replace all the batteries in the device at the same time.
• Remove the batteries if the remote control is not to be used for an extended time period.
• To avoid faults read the following instructions and handle the remote control properly.
• Do not drop the remote control or knock/slam it against a surface.
• Do not get water or any other liquid on the remote control.
• Do not place the remote control on a wet surface.
• Do not place the remote control in direct sunlight or near sources of heat.
NOTE: Remove the batteries from the remote control handset when it is not to be used for a long period to
prevent corrosion, battery leakage or physical injury and/or property damage, including fire.
Connect another external A/V equipment (refer to page 10).
Remote control range
Your LED TV can be operated from up to 5m away when the
remote control is pointed directly at the receiver.
S
pe
ci
fic
at
io
ns
Tr
ou
bl
es
ho
ot
in
g
U
si
ng
D
V
D
U
si
ng
T
V
In
st
al
lin
g
In
tr
od
uc
in
g
S
af
et
y
W
ar
ni
ng
s
Fe
at
ur
es
Fe
at
ur
es
LE
D
T
V
LE
D
T
V