11
WIND sensor
1.1
4.1
Factory setting
ACTIVATED
The anemometer (
ANEM4
) detects wind speed, which the control unit compares with the threshold set through
DIPs 1-2-3
(see table).
The control unit is only compatible with anemometers generating 4 pulses per rev.
ALARM ACTIVATED when
What happens with ALARM ACTIVATED
ALARM NOT ACTIVE when
The detected speed is higher than
the set threshold (see table at side).
The control unit tilts the pergola slats at
33%
of full
opening. The control unit executes
no command
.
The sensor has detected a lower speed
than the set threshold for 60 seconds.
L4
WIND
Alarm priority
HIGH
To manage the alarm associated with snow, the temperature and the rain sensors must be both activated.
SNOW condition
1.1
4.2
Factory setting
DEACTIVATED
SNOW
Alarm priority
MEDIUM-HIGH
ALARM ACTIVATED when
What happens with ALARM ACTIVATED
ALARM NOT ACTIVE when
The measured temperature is below 2 °C
and rain has been detected (see par.
4.4
)
The control unit tilts the slats to
66%
of full opening. The control
unit only executes
hold-to-run commands
.
The measured temperature is above 3 °C or
rain is no longer detected.
L4
The temperature sensor (NTC 10K/3435K) activates whenever there is danger of ice forming.
TEMPERATURE sensor
1.1
4.3
Factory setting
DEACTIVATED
TEM
PERATURE
Alarm priority
MEDIUM
ALARM ACTIVATED when
What happens with ALARM ACTIVATED
ALARM NOT ACTIVE when
The measured temperature is below 2 °C
and the slats are
closed
.
The control unit tilts the pergola slats to
10%
of full opening.
The measured temperature is above 3 °C or
any command is received.
t
°
L4
Activation/deactivation of the TEMPERATURE sensor by means of the transmitter *
Deactivation
Press the “
STOP
” button of a memorized 7/42
or 3-channel transmitter
10 times
and hold the
last time for
2 s.
The buzzer emits
2 beeps
.
L4
flashes once every
3 seconds
.
Activation (only if the sensor is connected)
Press the “
STOP
” button of a memorized 7/42
or 3-channel transmitter
10 times
and hold the
last time for
2 s.
The buzzer emits a continuous
sound for
4 seconds
.
STOP
L4 flashes
once every 3 s
(10x)
continuous
sound 4 s
STOP
(10x)
DIP1 DIP2 DIP3 Km/h
OFF
OFF
OFF
40
OFF
OFF
ON
45
OFF
ON
OFF
50
OFF
ON
ON
55
ON
OFF
OFF
60
ON
OFF
ON
65
ON
ON
OFF
70
ON
ON
ON
75
**
**
* The motors must be stopped. ** The motors make short movements