Teleco Magic Sat 2002A, Руководство по установке

Страница: 17 / 44

V006
Pag. 17
OPERATIONS FOR THOSE WITH GREATER EXPERTIS
Changing satellites during search
The Magic Sat Plus always starts its automatic search by examining the satellite which
transmits the last programme chosen before turning the system off (e.g. Astra, Channel 1).
Should you wish to launch an automatic search for another satellite, proceed as follows:
• Press the RED key on the remote control to swhitch on the system.
• Press the STOP key to stop the antenna temporarily (the words "Search suspended" will
be displayed on the TV set)
• Choose the new channel transmitted by the satellite you want (e.g. Channel 101, Hot
Bird)
• After a few seconds, the antenna will start searching again and will stop on the new
satellite (Hot Bird).
WARNING : if the antenna is stopped with the STOP button, this can only be restarted if a
programme transmitted by another satellite is selected.
Sequential satellite seeking
This kind of search is used only when you are at the edge of the reception area, where
signals are weaker, and only if Automatic Search has failed.
1 Turn the system on with the Red key
2 Interrupt the search pressing the STOP key
3 Press the MENU key
4 Choose CONFIGURATION
5 Choose SAT SEARCH
6 Choose SAT SEARCH: SEQUENTIAL using the key
7 Exit the MENU (See the Analogue Receiver instruction Manual)
8 Choose the programme you want (e.g.: 1)
At this point, the Magic Sat 2002A will start to search for the signal of the programme you
have chosen. When the antenna points at a satellite which transmits this signal, it will stop
and the following message will be displayed:
Should the programme appearing on the TV set be the one that interests you, press the
OK key; otherwise, press the NEXT key to make the antenna search for another Satellite
which transmits the programme you want. The SEQUENTIAL SEARCH for the chosen
channel (e.g. Channel 1) could fail too. In this case, press the Down key again to lower the
antenna and turn the system off. Since satellites transmit some channels with high power
and others with lower power, in case of failure, you would do best to try another search
changing the number
1) Press the Red key to turn on
2) Press the STOP key to interrupt the search